LAMBCO® BACKER ROD is available in a number or sizes ranging between 1/4” (0.635-cm) and 4” (10.16-cm) with respective container sizes based on diameter as per the below …

Standard Backer Rod is an extruded round, closed cell, low-density polyethylene foam material with skin-like outer texture. It is highly flexible and compressible for easy installation. Standard …

LAMBCO® BACKER ROD is available in a number or sizes ranging between 1/4” (0.635-cm) and 4” (10.16-cm) with respective container sizes based on diameter as per the below …

Sizing Chart on reverse side, select proper rod diameter and cut to length or use directly from spool. With a blunt instrument or roller, uniformly install rod at the level recommended by the …

Backer Rods are round, flexible lengths of foam that are used as a “backing” in joints or cracks to help control the amount of sealant used or the depth of the sealant in the gap.

Sizes: QUIKRETE® Backer Rod is packaged in 20 ft (6.1 m) lengths. Available in 1” (25 mm) and 3⁄4” (19 mm) diameter. The typical physical properties of QUIKRETE® Backer Rod are listed in …

Generally the depth of the joint after the Backer Rod is installed is one half the width. Very large and very small joints vary in terms of this depth to width ratio. Size and lengths per spool are …

Alcot Plastics Backer Rod is available in a wide variety of diameters and comes in 3 carton sizes. Please see the following chart for details on packaging. Diameter Carton Size Details …

Aug 15, 2019 · Generally the depth of the joint after the Backer Rod is installed is one half the width. Very large and very small joints vary in terms of this depth to width ratio.

For 3/4" (19 mm) wide joints, use 1" (25 mm) diameter rod. Select a backer-rod diameter that is approximately 25% larger than the width of the joint. See the yield table on the next page for …

the types of backer rod and how to choose the right type for your application. Why use Backer Rods? Backer rods are used as a “backing” material to fill a void, joint, or crack in residential …

View our backer rod manufacturer sizing and application chart. Featuring backer rod manufacturers like Denver Foam, Titan Foam, Mile High Foam, and more. Call DISSCO today …

Sizing Chart on reverse side, select the proper rod diameter and cut to length or use directly from spool. With a blunt instrument or roller, uniformly install rod at the level recommended by the …

By sealing the joint with an elastic sealant which durably allows max. 25% deformation, the minimal width of the joint is: (100/25) x 2,4 mm = 9,6 mm. Both the correct width and depth of …

Generally, the depth of the joint after the backer rod is installed is one half the width. Very large and very small joints vary in terms of this depth to width ratio. DO NOT PUNCTURE, …

By sealing the joint with an elastic sealant which durably allows maximum 25% deformation, the minimal width of the joint is: (100/25) x 2,4 mm = 9,6 mm. . Both the correct width and depth of …