kohler engine governor problems - Search
Open links in new tab
  1. How to Repair a Governor on a Kohler Engine - Hunker

    Disconnect the spark plug wire from the spark plug by pulling on the black rubber boot that covers the tip of the spark plug.

    Hunker

    Locate the throttle fly mechanism on the top of the carburetor. It should have a linkage spring that stretches horizontally to the L-shaped governor arm.

    Continue reading

    Loosen the nut on the bottom of the L-shaped governor arm about one full turn with an open end wrench to loosen the governor arm from the governor cross shaft.

    Continue reading

    Grasp the cross shaft just beneath the governor arm with a pair of needlenose pliers, and rotate the cross shaft counter-clockwise as far as it will turn. When it stops, hold it in place and pull back on the governor arm as far as it will go. Hold the two in place, and tighten the nut on the bottom of the governor arm (which you loosened in the pre...

    Continue reading

    Replace the air filter. Reconnect the spark plug wire to the spark plug. Start the engine. Allow it to warm up for about five minutes.

    Continue reading
    Feedback
     
    Kizdar net | Kizdar net | Кыздар Нет
  1. Some results have been removed