1. Materials: 1meter ws2812b 144LED/m IP30 $8.69 microcontroller (Arduino) $2.58 6 plexiglass squares (91*91*3mm) mirror film $2.19 (Product arrive...

2. This is the most important part of this project. The part is printed on one of its corners so there is less difference in layer lines and becaus...

3. It is important to understand how the wires need to be soldered before actually soldering them since there is not a lot of space to work with. T...

4. I am going to divide this section into sub-steps to explain everything better. I numbered the parts of the LED strip in the image above to expla...

5. Make sure to pay attention to the direction of the LED strip pieces! Placing one piece incorrect can give you a lot of trouble.Step 2: Now parts...

6. Make sure to pay attention to the direction of the LED strip pieces! Placing one piece incorrect can give you a lot of trouble.step 3: Right now...

7. Make sure to pay attention to the direction of the LED strip pieces! Placing one piece incorrect can give you a lot of trouble.Step 4: You are a...

8. As mentioned before, the sticky tape on the strip itself does not stick well to PLA. That is why I lifted all the LED strip pieces a bit and put...

9. Instead of cutting the acrylic in squares of 91mm, I used a ruler and a knife to make lines in the acrylic at points where I wanted to break it....

10. Here is a link to someone explaining how to do this, to summarize it: Clean acrylic, remove fibers or dust Apply soapy water to acrylic remove...