1. Here is a list of parts you'll need:FrameForkHeadsetRear derailleurFront derailleur (optional)BrakesBrake LeversShiftersHeadsetCable guide2 x de...

2. Grease chain tool allen keys wire cutters pedal wrench hacksaw nuts/bolts (or headset press) adjustable wrench bottom bracket tool screw driver

3. Insert the seat clamp, then the post. Grease the heck out of the part of the post that will be in the frame to keep it from rusting together. Th...

4. Install the headset first. I install the cups using a large bolt, some washers and a nut. The presses it in to place. There is also another inst...

5. Ok put the headset together, grease the bearings, put your stem and any spacers you are going to use on the fork and make a mark with a marker....

6. So now you take that fork out and cut it about 3mm below the mark you just made. I used a steerer tube cutting guide, but you can use a zip tie...

7. Now you have to drive in the star fangled nut. I thread it on the bolt. Then use a hammer and tap it in about 1cm.

8. Ok, put it back together. Tighten the top cap until its snug, but not too tight. Then tighten down the stem. You'll check it later.

9. Insert the bottom bracket. Grease up the threads. The drive side is REVERSE threaded. Don't forget it goes backwards. Start it by threading it i...

10. Now its time to use the tool and tighten the bottom bracket. Tighten the drive side, then the non drive side. The drive side will sit snug agai...