1. To start out, you need to clean the crack. Don't laugh.Using some hand rasps and some chisels, I took all the rough edges and splinters out of t...

2. Using a draw knife I took the bark off of both sides of the slab. Some people choose to keep the bark on a slab, so this part is a personal pref...

3. To make the inlays for the table I decided to use a piece of 1/4" bloodwood for the rebel symbol, and some katalox for the tie fighters and...

4. I started by laying down some painters tape over the areas where I was going to be putting the inlay pieces. Using the figures I cut out, I trac...

5. Using a chisel I cleaned up the edges of the mortises. I added glue to each mortise, then used a rubber mallet to gently tap the ships into plac...

6. Trying to do my best Kylo Ren impression, I grabbed some roofing tape and taped the bottom of the slab. I flipped the slab over and taped up the...

7. After it was cured, I removed the tape, then used a card scraper to even the epoxy down.This can also be accomplished with a sander, or planer,...

8. I wanted to have a wireless charger built into the desk that sat just below the rebel symbol, so I picked up a charger and set it on the bottom...

9. Wanting a sturdy pair of legs for this hefty slab to sit on, I asked a friend to weld up custom legs for my desk. The legs were designed with se...

10. I wanted to add a light effect to the bottom of the desk to shine through the crack in the desk, that made it look like the Millennium Falcon (...