1. The frame was made from 25mm steel angle 3mm thick. The angle was cut to the dimensions shown in the CAD sketch. The frame parts were clamped in...

2. The sidecar wheel was a standard 20" bicycle front wheel. The mounting was slotted to allow some degree height adjustment, but this could b...

3. The bodywork was made from plywood. 12mm thick plywood for the base and top deck. 4mm plywood for the curved sides. The overall dimensions were...

4. The wheel arch was two semi-circles of 12mm plywood with some 4mm ply bent over the top and secured with screws and glue. The wheel arch was not...

5. The pivot was a simple bar held in four mounting blocks. Two blocks on the bicycle and two on the sidecar. The sidecar pivot blocks were made ad...

6. Here are some general images to show the sidecar with the bike. Modifications ? A threaded bar instead of a pivot would be a simpler mounting an...

1. complete bicycle, third wheel,bicycle frame 

2.  i welded 1" tube frame to bike frame leaving room for foot to peddle

3. i welded and cut off 4-6 times this was not good spot 

4.  

5.  as you can see third wheel is still forward

6. i should have taken more photos but here it is as you can see third wheel is back supported by spare bike frame

7.  

8. sidecar i left open -more of a cargo carrier  

9.  

10.  not the best weld my first time to weld a project