1. These stars are constructed with 10 separate pieces of wood, all cut to the same shape. The wood grain runs parallel to all the outside edges of...

2. Table saw18 Degree Angle Cutting Jig or sled (you will make this)Ruler or tape measureStrait edge20" x 16" x 1/2 inch plywood (this wi...

3. First, make a jig so the pieces can be precisely cut to the exact angle of 18 degrees with your table saw.The Math... (base measurement times (t...

4. Next we will cut the 8 foot 1x4 or 2x4 into 5 pieces... each 14.5 inches long and set them aside. (I use a miter saw for this step)Next...With t...

5. Line the parts as shown with all the pieces up against the table saw fence, "cut face" down and trim about 1/8" to 1/4" from...

6. Sprinkle some fine sawdust on your work surface to prevent the pieces from sticking to the surface when you place the glued-up parts there.Run a...

7. After the 5 "petals" (I call them that) are set up... We will make the second cuts on the pieces.Remove Romex staples from the petals...

8. Place all the pieces on a flat surface and test fit them. It is almost certain that there will be a gap of some sort either toward the middle or...

9. If you are going to use Kreg screws... drill the holes for them now. Since I use Kreg screws to do final assembly of stars and for extra strengt...

10. Bevel the petals of the StarAt this point... Before glue up... if you started with a 2x4 in the beginning, you can bevel the petals of the star...